Installing a Star TSP100 USB interface printer requires the driver installation package supplied on CD with new Star printers or available for download at http://www.starmicronics.com. Do not connect the printer until after the drivers have been installed. The following images are taken from driver version 6.2 light. The light version is a smaller package that does not include documenation.

Note: When using a serial, Ethernet or parallel port printer, the Star drivers are not required. Install the printer normally using the Windows Add Printer wizard with generic/text only drivers.

1. Insert the CD that came with the printer or download and unzip the driver installation package from http://www.starmicronics.com. Allow the disk to auto run or double-click on autorun.exe. Click Install Now and review the License Agreement. Click I Accept if you have read and agree with the License Agreement.

2. Click Next on the welcome screen.

3. Review the customer information and the scope of the installation. Click Next.

4. Select Typical setup type and click Next.

5. Click Install to begin the installation.

6. The installation will take approximately 2 minutes. Do not interrupt the process or use other programs while the installer is running.

7. Click Finish to exit the installer.

8. Connect the printer to a free USB port on the POS station and power on the printer. The Windows Found New Hardware prompt will appear on the taskbar near the clock. After the device is installed, open the Windows Devices and Printers folder to confirm that the new printer has been installed and is on-line.

9. AmigoPOS can send commands to the Star TSP100 in either the Star or ESC/POS (Epson) command set. There are slight differences in the receipt output. To use the ESC/POS command set with the TSP100, open the Windows Devices and Printers folder and right-click on the Star TSP100 Cutter (TSP143).

10. Click Properties and select the TSP Config tab followed by Launch Configuration Application.

11. Select ESC/POS Mode and click OK.

12. Click Print Job Routing and check the box next to Enable ESC/POS Routing. Click Apply Changes and Close.

13. In AmigoPOS, navigate to Back Office | Settings | Devices and select the printer name from the drop-down list. Select the appropriate printer type and click the Test Receipt button to confirm that the printer is installed correctly.